Argon gas discharge lamp

By applying a sufficiently high DC voltage across a gas, the gas atoms/molecules are ionised by the strong electric field. In this project, we construct an Argon-based gas discharge lamp, with adjustable pressure and voltage. The breakdown voltage of Argon gas with respect to pressure changes is observed, and compared with Paschen's law. We also observe changes in the spectroscopic properties of the plasma with varying pressure.

Setup

A small air-tight chamber was evacuated with a rough pump to about $3\times 10^{-3}$ Torr (measured with a Pirani gauge). Then, Argon gas was slowly introduced to the chamber via a needle valve, until the chamber reached the pressure of about $10^{-1}$ to $10^{0}$ Torr. The metallic cylinder that interfaces with the gas lines forms the cathode of the chamber, and is grounded. Another metallic cylinder (anode) was attached to the cathode using a glass pipe.

The glass pipe provides an electrical isolation between the cathode and the anode, and provides a viewport for the experimenter to observe glow discharge. The anode was connected to the positive terminal of a high-voltage power supply, which can reach upto 760 V. Epoxy was used to connect the pieces and seal the vacuum chamber. A ballast resistor (33 kΩ) was added in series with the gas discharge lamp in order to limit the current. The electrodes were mechanically held using laser-cut acrylic plates fixed to an optical breadboard using brackets and bolts. Multimeters were used to monitor the current and the voltage across the lamp.

Schematics for the Argon gas discharge lamp setup

Argon gas discharge lamp setup

Measurements

The chief advantage of our setup is the capability to adjust the pressure of the Argon gas.

Glow Discharge

We qualitatively observe the changes in the spectroscopic properties in the stable DC Argon plasma, as we vary the pressure.

File:Argon-lamp-glow.mp4

Glow discharge colour change

Paschen's Law

The ions and free electrons produced from a sufficiently high voltage (above breakdown voltage) move towards the respective electrodes, and current is formed across the lamp. The moving charges collide with other particles to multiply the number of charge carriers in the gas. This process is known as Townsend avalanche or multiplication. The excited atoms and ions decay to the ground state and emit light, in the form of glow discharge.

The change in the breakdown voltage with respect to the pressure of the gas can be described by Paschen's Law, according to which the breakdown voltage given by

$V_{\text{B}}={\frac {Bpd}{\ln {(Apd)}-\ln {{\Big [}\ln {{\Big (}1+{\frac {1}{\gamma _{\text{se}}}}{\Big )}}{\Big ]}}}}$

where $p$ is the pressure, $d$ is the distance between the electrodes (here, $d$ is constant), $\gamma _{\text{se}}$ is the secondary-electron-emission coefficient, and $A$ and $B$ are empirically determined constants. $A$ represents the saturation ionisation, and $B$ is related to the excitation and ionisation energies.

The above graph illustrates qualitatively how the breakdown voltage varies with pressure, under Paschen's law. When the pressure decreases, the mean free path of the moving charges increases, enabling them to accumulate sufficient energy for the multiplication process with a lower required applied voltage. At the same time however, the collision cross-section also decreases, reducing the occurrence of ionising collisions. At a very low $pd$, the latter effect dominates, and thus a high voltage is needed for the multiplication to begin.