Smoke detection in air: Difference between revisions

From PC5214 wiki
Jump to navigation Jump to search
No edit summary
Line 28: Line 28:




=== Component List ===
=== Laboratory Equipment ===
: 1)  DC Voltage source (MATRIX MODEL: MPS-3005L-3)
: 1)  DC Voltage source (MATRIX MODEL: MPS-3005L-3)
: 2)  MODEL SR830 DSP Lock-In Amplifier
: 2)  MODEL SR830 DSP Lock-In Amplifier
Line 36: Line 36:
: 6)  Resistor (1.2K)
: 6)  Resistor (1.2K)
: 7)  LED (Green)
: 7)  LED (Green)


=== Schematics ===
=== Schematics ===

Revision as of 15:34, 28 April 2022

Introduction

Smoke detector is a device that senses smoke, typically as an indicator of fire. Commercial smoke detectors issue a signal to a fire alarm control panel as part of a fire alarm system. Household smoke detectors, also known as smoke alarms, generally issue an audible or visual alarm from the detector itself or several detectors if there are multiple devices interlinked [1].


Lock-In Amplifier

Measure small signals in a large background (huge noise).



Mathematical Description


Signal Process


Logic Flow


Experiment

We can divide this experimental setup into two parts: the first part will detect the scattering light in the air, and the second part will amplify such signal.


Laboratory Equipment

1) DC Voltage source (MATRIX MODEL: MPS-3005L-3)
2) MODEL SR830 DSP Lock-In Amplifier
3) BWP34 Silicon PIN Photodiode
4) WAVESURFER 104MXS Oscillator
5) Capacitor (50V 22uF)
6) Resistor (1.2K)
7) LED (Green)

Schematics


Detection Setup

In this part, we use BWP34 Silicon PIN Photodiode as the detector. Here the capacitor and resistor are used to protect the photodiode.


Lock-In Amplifier Setup

A lock-in amplifier is a type of amplifier that can extract a signal with a known carrier wave from an extremely noisy environment.

Video

In this video Media:SMOKE_VIDEO.mp4, we have recorded the voltage change in the lock-in amplifier under the situation when the smoke (vaporised tin) gradually drifts in, maintains and finally disappears.


Data Plot


Error Analysis

Conclusion

Conclusion on Result

From the data we can conclude that the smoke detector works since we can clearly distinguish the presence (low voltage) or absence (0 volt) of smoke.


Further Discussion

Due to lack of measurement means and smoke with wide range of particle sizes, our group could not quantify the smoke and calculate the accuracy of the smoke detector. However, we have a rough idea:


Reference

Error Analysis in Experimental Physical Science: https://faraday.physics.utoronto.ca/PVB/Harrison/ErrorAnalysis/ErrorInMean.html